1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi
Getting Started with 10.3inch flexible E-Ink display HAT
If you need a large E-Ink display HAT for Raspberry Pi then take a look at this 10.3-inch flexible display. The display quality of this E-Ink HAT is 1872x1404p. It contains an IT8951 controller. The 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi supports USB, SPI, I80, and I2C interfaces. In addition, it is capable of the partial refresh.
You can bend the e-Paper panel which is thinner as well as lightweight as compared to the conventional e-Papers. It is a low-power display HAT that keeps displaying for hours even without the availability of power. The view-angle is wider and this is why it is best for industrial instruments, eBook Reader, etc. It is a bicolor display that features high-contrast black and white colors.
Video Presentation of the Product
Features of 1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi
- Comes with a thinner and flexible e-Paper which you can easily bend (NEVER bend the FPC area)
- No backlight – it is power efficient/ultra-low-power display
- Capable of partial refreshing
- Compatible with 40-Pin GPIO (Standard Raspberry Pi)
- Compatible with Raspberry Pi boards
- Supports connectivity via USB, I2C, SPI, and I80
- Resources and manual included for Raspberry Pi and STM32
![](https://cdn.shopify.com/s/files/1/0252/6615/9704/files/SPI_Pinouts_480x480.jpg?v=1653762405)
Specs of 1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi
- Operating Voltage: 5V Compatible
- Interface: I2C, SPI, I80, USB
- Display Quality (Pixel Resolution): 1872x1404p
- Colors: High-contrast Black and White
- Dimensions of the display: 209.664mm x 165.8mm x 0.647mm
- 112mmx0.112mm Dot-Pitch
- 2-16 GrayScale (1-4 Bit)
- Refresh Power )Total): 1.2W (typ.)
- Refresh Time (Full): 450ms
- Standby Power (Total): 0.1W (typ.)
- View-Angle >170o
- Outline Dimensions (Edge-to-Edge): 227.7mm x 165.8mm x 0.647mm
Dimensions of the E-Paper HAT
Items Included
- 1x 33-Pin FCC (Same-Side Contact)
- 1x e-Paper adapter
- 1x IT8951 e-Paper Driver HAT (B)
- 1x PH2.0 20cm 8-Pin
- USB (Type-A) to Micro B Cable
- 1x e-Paper (D) 10.3-inch
- 2x Screws (For Raspberry Pi)
Caution
-
DO NOT try to bend the FPC Area
Disclaimer
-
Raspberry Pi board is NOT included