Unfortunately, purchases from your country are currently not supported.

Please contact our support team if you believe this is a mistake.

Assembly Instruction KKSB Raspberry Pi 5 M.2 HAT Case

  1. Attach the rubber feet, place the Raspberry Pi into the case, and install the stackable 40-pin header.

  2. Tighten the hexagonal standoffs. This can be done by hand, but using a socket is highly recommended.

  3. If you are using the NVMe HAT or another hardware module, you can connect it now. In this step, also mount the cooler. It is missing in the pictures.

  4. Secure the HAT with the four screws.
  5. Snap the lid into place.

  6. Finish