1. Assemble the cooler with the Raspberry pi 5.

2. Assemble the internal brackets on the display. Put the display board on top of the brackets. linke in the picture.

3. Assemble the Raspberry Pi 5 to the bracket.

4. Insert the frame and tighten the 4 screws.

5. Wire the cables according to the picture below.

6. Wire the Display Cable according to below and this is how it should look like now

7. This is how you insert or remove Micro SD card with the included tweezer.

8. Close the bottom plate.

9. Insert the push button on the Micro SD Lid and carefully insert the lid and button from the side.