These instructions apply to two distinct low-profile display cases, identified by article numbers 7350001162058 and 7350001162096.

1. Start with these parts.

2. Put the cover on top of the display on a flat surface.

3. If necessary, loosen the frame screws to ensure the display fits, and then tighten them again later.

4. Tight these screws.

5. Tight those screws.

6. Put the Raspberry Pi 5 on the standoffs and connect the cables.

7. Mount the standoffs.

8. Insert the side panels in the holes and hold them with your hand. Align them as good as possible so it will be easier in the next step.

9. Mount the top plate. Start from one side and then mount it flat.

10. Tighten the screws carefully—do not overtighten them, as this could affect the alignment of the Raspberry Pi 5 connectors.

From this point on, the steps depend on the case model you purchased. If they don’t apply to you, simply move on to the next step.

For 7350001162058 (desktop style/no stand):

11. Assemble the legs and put on rubber feet. Done!

For 7350001162096 (The stand version case):

12. Put rubber feet on the fot.

13. Tight the screws for the Swivel unit.

14. Mount the Black distance to the thread.

15. Mount the two assemblies together. Done!