Assembly Instruction KKSB Arduino Giga Display Shield Case With Adjustable Stand

1. Assemble the blue spacers and the camera header.

2. Mount the Arduino Giga on the display.

3. Remove this screw before inserting the electronics into the case.

4. Tighten the screw again.

5. Insert the push buttons and mount the lid to the case in upright position to prevent the push buttons to fall out.

6. Tighten the screws.

7. If you intend to not use the stand you can now mount the rubber feet.

8. If you plan to use the stand this is how you prepare it:

9. Assemble the stand with the case assembly.