SX1262 915MHz LoRa HAT for Raspberry Pi – America, Asia, Oceania

€20,90

Download SX1262 LoRa HAT User Guide and Resources

This SX1262 LoRa Spread Spectrum Modulation HAT is compatible with Raspberry Pi. This HAT supports the 915 MHz frequency band and can operate in America, Asia, and Oceania regions. It uses the serial port for data transmission with a range of up to 5 kilometers. The module comes with auto repeating, wireless configuration, Wake on Radio, communication key, and carrier sensing features. The Spread Spectrum Modulation technology enables the SX1262 LoRa HAT to cover a greater distance with low power consumption and at a higher rate. This HAT is ideal for smart home, industrial control, and data collection applications.

Features of SX1262 915MHz LoRa HAT for Raspberry Pi

  • Standard 40-PIN GPIO Extension Header
  • Serial debugging through the CP2102 onboard USB to UART converter
  • Supports Host boards including ST32 and Arduino via UART control interface
  • Module operating status indicator LEDs x4
  • LoRa Spread Spectrum Modulation Technology
  • Maximum 81 signal channels; resists interference; longer range
  • Auto multi-level repeating is suitable for long-range data communication and supports multi-network within the same region
  • Wake on Radio and deep sleep features for low power consumption. This feature is highly suitable for battery-powered applications
  • Configurable communication key with no retrieving. Ideal for user data security.
  • LBT support. Monitors the signal channel noise before it is transmitted. It significantly improves the success ratio under harsh weather or environmental conditions.
  • RSSI signal intensity indication support. Performs signal quality evaluation and network tuning
  • Wireless parameter configuration support. Receives wireless data / command packets to allow remote configuration and retrieving the module parameter
  • Supports broadcast, fixed-point transmission, and signal channel monitoring
  • User manual, development resources, and examples for STM32 and Raspberry Pi

Hardware Components

  • LoRa Module SX1262
  • Voltage Level Translator 74HC125V
  • USB to UART converter CP2102
  • Standard 40-PIN GPIO Extension Header
  • USB to UART port
  • IPEX antenna connector
  • SMA Antenna connector
  • UART header for Host board connection
  • AUX – Auxiliary Indicator
  • RXD / TXD – UART RX / TX Indicator
  • PWR – Power Indicator
  • UART selection jumper A: Control the LoRa module through USB TO UART
  • UART selection jumper B: Control the LoRa module through Raspberry Pi
  • UART selection jumper C: Access Raspberry Pi through USB TO UART
  • LoRa mode selection jumper short M0, short M1 – Transmission Mode
  • LoRa mode selection jumper short M0, open M1 – Configuration Mode
  • LoRa mode selection jumper open M0, short M1 – WOR Mode
  • LoRa mode selection jumper open M0, open M1 – Deep Sleep Mode

Form Factor

  • Dimensions: 65 mm x 30.5 mm | 6.5 cm x 3.05 cm
  • Weight: 69 Grams

Items Included

  • SX1262 LoRa HAR 915MHz (x1)
  • Antenna 915MHz (x1)
  • USB Cable Type-A to Micro (x1)

Note: Raspberry Pi is NOT included

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)