1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi

€242,90

If you need a large E-Ink display HAT for Raspberry Pi then take a look at this 10.3-inch flexible display. The display quality of this E-Ink HAT is 1872x1404p. It contains an IT8951 controller. The 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi supports USB, SPI, I80, and I2C interfaces. In addition, it is capable of the partial refresh. You can bend the e-Paper panel which is thinner as well as lightweight as compared to the conventional e-Papers. It is a low-power display HAT that keeps displaying for hours even without the availability of power. The view-angle is wider and this is why it is best for industrial instruments, eBook Reader, etc. It is a bicolor display that features high-contrast black and white colors.

Features of 1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi

  • Comes with a thinner and flexible e-Paper which you can easily bend (NEVER bend the FPC area)
  • No backlight – it is power efficient/ultra-low-power display
  • Capable of partial refreshing
  • Compatible with 40-Pin GPIO (Standard Raspberry Pi)
  • Compatible with Raspberry Pi boards
  • Supports connectivity via USB, I2C, SPI, and I80
  • Resources and manual included for Raspberry Pi and STM32

Specs of 1872x1404p 10.3-inch Flexible E-Ink Display HAT for Raspberry Pi

  • Operating Voltage: 5V Compatible
  • Interface: I2C, SPI, I80, USB
  • Display Quality (Pixel Resolution): 1872x1404p
  • Colors: High-contrast Black and White
  • Dimensions of the display: 209.664mm x 165.8mm x 0.647mm
  • 112mmx0.112mm Dot-Pitch
  • 2-16 GrayScale (1-4 Bit)
  • Refresh Power )Total): 1.2W (typ.)
  • Refresh Time (Full): 450ms
  • Standby Power (Total): 0.1W (typ.)
  • View-Angle >170o
  • Outline Dimensions (Edge-to-Edge): 227.7mm x 165.8mm x 0.647mm

Unboxing

  • 1x 33-Pin FCC (Same-Side Contact)
  • 1x e-Paper adapter
  • 1x IT8951 e-Paper Driver HAT (B)
  • 1x PH2.0 20cm 8-Pin
  • USB (Type-A) to Micro B Cable
  • 1x e-Paper (D) 10.3-inch
  • 2x Screws (For Raspberry Pi)

Caution

  • DO NOT try to bend the FPC Area

Disclaimer

  • Raspberry Pi board is NOT included

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)